Does this part exist by itself?

[Audiudo]

Found the culprit of a leaky washer fluid tank. There is a plastic elbow that connects to the washer pump and it is cracked. Can I get this part by itself? Pic below.

[julex]

doubt it, looks like it is a part of a hose that's thermally molded over the barb of this part.

[alistairogrady]

Don't know, but that may be the reason for my fluid loss over a few days? Could you use self-amalgamating tape to repair?

Alistair

[Audiudo]

Thanks for the replies guys. Tape is a good idea. I'll try that route.

[4rings2turbos]

If you can find a fitting that is similar you can remove the old fitting by heating up the hose with a heat gun or even hair dryer making it pliable so the old fitting can slide out.

[LakeTahoeQuattr]

Parts yard or pick n pull

[mbagge01]

I have the same problem and did some research on ETKA, and below is the part that corresponded to replacing that elbow. I am going to try and see if it works.

http://www.rmeuropean.com/make/partn...rch=1j0955665h