Quote Originally Posted by Tumbler510 View Post
I was using 1/4" silicon hose from McMaster.

Jack up car
Remove skid plate
Drop sway bar
Locate actuator fittings visually
Remove rubber hose from actuator using long thing (hand, screwdriver, crowbar)
Remove hose from Tee (top/behind engine)
Route replacement line from Tee down
Put hose clamp over end of line before attaching to actuator fitting
Fit hose over fitting using hands (will not be able to see what you're doing)
Secure clamp with screwdriver/nut driver/ratchet
Secure line at top using clamp
Secure line along route down with zip ties

Pretty straight forward.
Like most things on these cars, its a simple thing, but simple doesn't equal easy.
I removed original line that has hard sections with an entire piece. I thought about just using hose but I was concerned about hose being that close to the exhaust. I'm sure just using hose for the entire thing would be easier but like I said..... that is a lot of heat inches away.

Did you only remove sway bar at the frame or also at the wheels?