Audizine - An Automotive Enthusiast Community

Results 1 to 10 of 10
  1. #1
    Active Member Two Rings
    Join Date
    Jun 03 2010
    AZ Member #
    59838
    Location
    glendora/ca

    Does the dealership have a new flash that erases or overpowers tunes??

    Guest-only advertisement. Register or Log In now!
    Hi,
    So I am or was running Stage 2 Revo tune and I went in for the Ignition Coil recall (07 2.0 A3). I have the Select switch and I turned car back to stock map before going in for the service. After the service, I re-loaded the stage 2 map and was good for about 3 engine on-off cycles, boosting to 22-24 psi. 4th engine start, I was still boosting stage 2 levels then all of a sudden, it reverted to stock map, boosting around 15 or so psi. I tried re-loading the software again and again, and the same results would happen each time. I can hit boost about 30 os so times at stage 2 levels then it reverts back to stock map it seems.

    Anyone else experience this and can advice on what to do?

    Thanks!

  2. #2
    Veteran Member Four Rings bman005's Avatar
    Join Date
    Sep 06 2011
    AZ Member #
    80891
    My Garage
    2015 Silverado, 2012 A4 Avant. Former; 90 Corrado, 97 Golf, 05.5 A4, 2010 Tiguan
    Location
    Harrisburg, Pa

    Thats really weird. But any reflash of your ECM by the dealer will most likely erase your tune. The coil campaign however, does not include a flash. Did the dealer do anything else?
    New Build, 2010 Tiguan. Details to com

  3. #3
    Active Member Two Rings
    Join Date
    Jun 03 2010
    AZ Member #
    59838
    Location
    glendora/ca

    No--just the ignition coil recall. REVO said it might be due to low voltage, but the lowest I have seen while driving is 13.8v and before starting the car, it is at the least 12v. I don't think it is a boost leak also or anything mechanical either because I am not getting any CELs or codes, nor is driveability compromised in any way. And when I reload the stage 2 map, it boosts fine for quite a while and then it seems to just turn off during regular driving. I am now thinking I bought the car with trial software and am just turning it on each time I use the Select switch. I'll be going to a REVO dealer soon...or Unitronic..

  4. #4
    Active Member Two Rings Vale's Avatar
    Join Date
    Feb 01 2012
    AZ Member #
    87562
    My Garage
    Mini Cooper Clubman S
    Location
    Caguas/Puerto Rico

    Quote Originally Posted by victorr View Post
    No--just the ignition coil recall. REVO said it might be due to low voltage, but the lowest I have seen while driving is 13.8v and before starting the car, it is at the least 12v. I don't think it is a boost leak also or anything mechanical either because I am not getting any CELs or codes, nor is driveability compromised in any way. And when I reload the stage 2 map, it boosts fine for quite a while and then it seems to just turn off during regular driving. I am now thinking I bought the car with trial software and am just turning it on each time I use the Select switch. I'll be going to a REVO dealer soon...or Unitronic..
    I had a coil recall on my A3 2006 but they did not mess with the comp. I have APR stage II but I only get 17 psi boost . 22 to 24 sounds kind of hight 15 to 17 sounds better for a stage II. But any way do you have the original diverter valve? They are very weak specially with the upgrade. Also you may check for boost leaks and spark plugs calibration I use 28 on my plugs. Make sure all clapms are tight and no leaks.

    Hope this help

  5. #5
    Veteran Member Four Rings BASARAB's Avatar
    Join Date
    Mar 01 2010
    AZ Member #
    55352
    Location
    Farmington Hills,Mi

    are you sure that your boost gauge just not acting funny?

  6. #6
    Active Member Two Rings
    Join Date
    Jun 03 2010
    AZ Member #
    59838
    Location
    glendora/ca

    Yeah, still happening. Cleaned my MAF and installed Forge DV. Car also has no leaks because it boosts fine after loading the stage II map. I'll boost at 22-24 pounds for an infinite amount of times . ...and then it just reverts to stock boost as if the stage II map was turned off. I'm really thinking the car was sold to me by the PO with trial software and all I'm doing is reactivating it each time I use the Select switch. Either that or the Select switch is faulty and not loading the map correctly (in the instructions of the switch it says to re-load the map 2 times if the switch was used on another car). Come to think of it, this only started happening after using the switch. I also have DEFI gauges so I can record boost levels, EGT, etc., so I know for sure my boost readings are legit.

    In any event, I will be going to a REVO dealer in a couple of weeks to get this sorted out. Thanks for the advice so far gents.

  7. #7
    Veteran Member Four Rings jimrobbington's Avatar
    Join Date
    Dec 03 2008
    AZ Member #
    35950
    My Garage
    2018 SQ5
    Location
    Castle Rock, Colorado

    It is not possible, afaik, to reset the trial tune. But this still sounds exactly what happened to me when my dv failed. I know you have a Forge, but they still fail. You should pull it, open it up, clean and oil it. The spring and piston inside can get caught not allowing movement, or hampering movement. This, or the tune.
    2021 Audi S4, P34 Intake

  8. #8
    Veteran Member Four Rings DRAKLORE's Avatar
    Join Date
    Oct 14 2009
    AZ Member #
    49253
    My Garage
    '81 Mk1 VW CADDY/2012 Honda Ruckus
    Location
    Okinawa Japan

    First thing I'm thinking is that your DV has gone bad. If your dealer did something to your tune it would happen immediately...
    -Shane Drake-
    1981 VW Caddy 5.4L V8 Swap Speedhunters Feature!
    2006 A4 Avant Dolphin Grey
    2007 GT3071R A4 Moro Blue-RIP
    >DRAKLOREs Build<
    Formerly DRAKES-PERFORMANCE

  9. #9
    Veteran Member Four Rings Militant-Grunt's Avatar
    Join Date
    Oct 30 2006
    AZ Member #
    12999
    My Garage
    B8 A4 Avant 6spd
    Location
    NYC

    If a ECU flash is performed by the dealership then yes, it will erase the tune.
    -MilitantGrunt- Certified Audi Dealership Technician / Parts Manager
    -18 718 GTS
    -10 B8 A4 Avant - 6spd swapped / built motor / Pag Parts EFR 7163 Turbo Setup.

  10. #10
    Active Member One Ring
    Join Date
    Nov 12 2011
    AZ Member #
    83808
    Location
    Paramus, NJ

    +1

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


    © 2001-2025 Audizine, Audizine.com, and Driverzines.com
    Audizine is an independently owned and operated automotive enthusiast community and news website.
    Audi and the Audi logo(s) are copyright/trademark Audi AG. Audizine is not endorsed by or affiliated with Audi AG.