View Full Version : ECU for 2.7biturbo APB engine?
In the middle of doing a engine swap, and need a ECU for the new engine, which is a APB engine 2.7biturbo 254ps.
As for now, i have come up with the info that is uses a Bosch ME7.1 ECU with part nr. 8D0907551H.
But can anybody confirm this or direct me to the correct one?
Thank you
blitz2190
12-30-2016, 07:27 AM
any apb ecu will work, you can put any tune on them, just be sure its for a 2.7t apb and not a bel. again since your are doing a b6 swap you would get answers quicker about the swap if you ask in the b6 forum there is an official swap thread that helps with this stuff.
Ephry73
12-30-2016, 08:00 AM
In the middle of doing a engine swap, and need a ECU for the new engine, which is a APB engine 2.7biturbo 254ps.
As for now, i have come up with the info that is uses a Bosch ME7.1 ECU with part nr. 8D0907551H.
But can anybody confirm this or direct me to the correct one?
Thank you
In my conversion the ecu from the donor C5 was used with a custom tune. I'm actually going to start tweaking a nefmoto tune so that I can have the tune I want exactly.
Try to go over to the 2.7 DIY post. Tons of information there.
Sent from my iPhone using Tapatalk
blitz2190
12-30-2016, 08:57 AM
In my conversion the ecu from the donor C5 was used with a custom tune. I'm actually going to start tweaking a nefmoto tune so that I can have the tune I want exactly.
Try to go over to the 2.7 DIY post. Tons of information there.
Sent from my iPhone using Tapatalk
one small caveat with a6 ecu's, there is a small tab in them that prevents them from plugging into a s4 harness, if you use a small pair of needle nose pliers and break the tab out it plugs in and works fine. No idea why because both harnesses work the same, maybe a way to charge more for replacements, not a clue.
one small caveat with a6 ecu's, there is a small tab in them that prevents them from plugging into a s4 harness, if you use a small pair of needle nose pliers and break the tab out it plugs in and works fine. No idea why because both harnesses work the same, maybe a way to charge more for replacements, not a clue.
Which means that i can use a AGB S4 ECU on my setup?
Nollywood
01-05-2017, 11:15 AM
Which means that i can use a AGB S4 ECU on my setup?
Yes, you can.
Just remember, you'll either have to have IMMO defeated, or matched to your cluster.
Ephry73
01-05-2017, 01:13 PM
Or get the M tune without immo already. After taking the ecu out of my B6 in favor of an MTM tuned ECU I discovered the tune was c5 A6 stock tune
6spd manual
Immo delete. Not sure who tuned it but it worked great. Slightly higher boost than stock rear O2 defeated as well.
http://uploads.tapatalk-cdn.com/20170105/c9eeaa778deae96e795dd74f61c196f2.jpg
Sent from my iPhone using Tapatalk