b8s4me
08-14-2016, 04:44 PM
I just had a brand new Eurocode flywheel installed with a stage 2 Southbend drag clutch. I went ahead and also replaced the throwout bearing, pilot and flywheel needle bearings, clutch fork and release arm, the relese pin, flywheel bolts, slave cylinder and stainless steel UPS clutch line as well. When the shop installed everything, the car wouldn't start with the pedal fully depressed, so they ended up lengthening the slave cylinder rod.
My friend picked the car up for me since I'm out of state, and he said that it makes noise when depressed. I brushed it off since I understand there will be significant chatter, but when he sent me the video it's clear something is wrong. He also says that you can shift gears with the clutch pedal only 1/2 depressed. The car, however, will NOT start unless the pedal is fully depressed. The shop is going to take another gander tomorrow, but does anyone have any idea what this could be? Thanks [:(]
P.S: I could upload the video if there is a way to do it from my iphone, imgur.com doesn't support the video file for some reason
My friend picked the car up for me since I'm out of state, and he said that it makes noise when depressed. I brushed it off since I understand there will be significant chatter, but when he sent me the video it's clear something is wrong. He also says that you can shift gears with the clutch pedal only 1/2 depressed. The car, however, will NOT start unless the pedal is fully depressed. The shop is going to take another gander tomorrow, but does anyone have any idea what this could be? Thanks [:(]
P.S: I could upload the video if there is a way to do it from my iphone, imgur.com doesn't support the video file for some reason