View Full Version : Motor Mount code?
enigma1406
01-27-2015, 06:33 AM
2013 Audi S6 that is throwing a code for module BA-Motor Mounts. Could this be as simple as an unplugged harness?
-------------------------------------------------------------------------------
Address BA: Motor Mounts (J931) Labels: 4H0-907-145.clb
Part No SW: 4H0 907 145 HW: 4H0 907 145
Component: AEM - LEAR H05 0006
Revision: 00001001 Serial number: 97804001859904
ASAM Dataset: EV_AEMLearAU64X 002014
ROD: EV_AEMLearAU64X.rod
VCID: 66C8387F998BE011F57-8033
1 Fault Found:
1295 - Drivetran Mounting
C1154 02 [009] - Signal Failure
Confirmed - Tested Since Memory Clear
Freeze Frame:
Fault Status: 00000001
Fault Priority: 1
Fault Frequency: 1
Reset counter: 12
Mileage: 33933 km
Date: 2015.01.22
Time: 22:46:59
Based on the reset counter it looks like it might have just been a transient issue.
siberianwolf
01-28-2015, 09:25 AM
got the same error, dealer replaced engine mount and some retaining plates under warranty
only mine did a bit more errors
1 Fault Found:
1295 - Drivetran Mounting
C1154 02 [009] - Signal Failure
Confirmed - Tested Since Memory Clear
Freeze Frame:
Fault Status: 00000001
Fault Priority: 1
Fault Frequency: 1
Reset counter: 102
enigma1406
01-28-2015, 10:57 AM
got the same error, dealer replaced engine mount and some retaining plates under warranty
only mine did a bit more errorsThanks for the reply. Mine is at the dealership as we speak. Getting a couple TSBs looked at and the motor mount error looked at. I'll post back with what happens so we have two instances of this for search!
headcase
08-08-2015, 01:01 AM
Curios to know what the outcome was, as I too am seeing this error pop up on my vag-com.
siberianwolf
08-09-2015, 12:14 AM
mine appeared again and keeps appearing, they wanted to replace mount again even though it's clear it's a contact/harness issue. I swear local dealer SA/techs are mindless drones
headcase
08-09-2015, 01:38 PM
Per the TSB, I suspect it can be resolved via the software update to the J931 module:
http://www.revbase.com/BBBMotor/TSb/DownloadPdf?id=183808
FWiW I wound up having to get one of my mounts replaced.
siberianwolf
08-10-2015, 01:13 AM
Per the TSB, I suspect it can be resolved via the software update to the J931 module:
http://www.revbase.com/BBBMotor/TSb/DownloadPdf?id=183808
Thanks! I will print out this and bring it with me when visiting dealer for next service. Problem with them is that for each thing, however small, I complain about they require car to be 1 week with them for "testing".
siberianwolf
08-10-2015, 01:15 AM
Per the TSB, I suspect it can be resolved via the software update to the J931 module:
http://www.revbase.com/BBBMotor/TSb/DownloadPdf?id=183808
Thanks! I will print out this and bring it with me when visiting dealer for next service. Problem with them is that for each thing, however small, I complain about they require car to be 1 week with them for "testing".