PDA

View Full Version : please help me with my sub installation with pictures is damaged?


marcink99
06-07-2008, 01:14 PM
ok while removing door panels one of my metal clips fell in how can i get it out?
http://pooltabletechs.com/Photo-0041.jpg


two when i removed my glove box there was a lot of foam that blocked my power wire to go through so i damege that foam.Does this foam has any effect on the car? It make me wonder as if it was part of the vantilation system perhaps?

http://pooltabletechs.com/1.jpg
http://pooltabletechs.com/2.jpg
[can i use isolation tape for my power wire? to protect it from the water.
http://pooltabletechs.com/Photo-0042.jpg
marcink99
06-07-2008, 09:33 PM
bump bump how can i get this clip out ;(
Kschroers1
06-07-2008, 09:46 PM
your probably not going to if it feel down into the body of the car. Your sol and will haft to get a new clip. And why are you running your positive cable like that? not a real clean/stealth look to be honest.
a4b7
06-07-2008, 10:58 PM
lol dont worry about the clip..its gone! you will have to buy new ones. I lost a couple like that also, but if your carpet/plastic still attaches firmly to the car without any major gaps or loose fitment..then i would just forget it.
a4b7
06-07-2008, 10:59 PM
as far as the power cable.. i would wrap it in black wire loom and move it around the battery so it wont be on the top of the battery. here is how i did mine:
http://www.audizine.com/gallery/data/500/9418016.jpg
Jay B7
06-08-2008, 01:31 AM
Not to flame or anything but here's a good example of why you should not DIY with no experience.