PDA

View Full Version : Simplified Radar Hardwire



FtLauderdaleA4
05-17-2008, 04:12 PM
hey guys,
thought Id share my hardwire setup with you.
no running things down to the fusebox or other complicated mods

1. remove the center console (detailed elsewhere). use torx screwdriver
2. the sunroof motor is visible (big silver colored box)
3. detach the blue colored relay located on the right side of the sunroof motor
4. there are 5 wires. two of them are larger than the others. there is a large red wire and a large brown wire.
5. you may have to remove some of the cloth tape, i used a razor blade.
5. tap your (+) wire from the radar to the red. i used a T-tap
6. tap your (-) wire from the radar to the brown. T-tap again
7. alternately, strip a little of the (-) radar wire and ground it to one of the empty hole located on the inside roof. i stole one of the screws holding up the console for this.
8. replace the relay. test. then tuck everything up inside and close.
9. thats it.

total time <10 minutes.
hope this helps
ill try to get some pics up

PolishPete
05-17-2008, 07:47 PM
Pics!!

Ski DraGoN
05-17-2008, 08:16 PM
Pics!!

+1

enigma1406
05-17-2008, 08:28 PM
I don't see how running wire to the fuse box is complicated. It takes no time at all and all you need is a fuse tap. No wire splicing/cutting/tapping.

bcramer
05-18-2008, 02:04 AM
Props to you for figuring out another way to do it. [up] Options are always great!


I don't see how running wire to the fuse box is complicated. It takes no time at all and all you need is a fuse tap. No wire splicing/cutting/tapping.

However, I do agree with the above statement. I personally don't like T-taps either...as I have experienced them failing and causing a lot more problems than they were worth. I know only solder all my connections, no more taps. Just a personal thing though.