First of all, HUGE props to "FatAuto" for figuring this out. For reference >>> FatAuto's AW Link

Here's how I did it and I've just include lotso pics for people who like pics

1. Identify wires (Position #1 & #2) on the light switch harness


2. Cut Wire #2. Allow for ample wire for step #3 & #4 below.


3. Strip Wire #2.


4. Crimp on Male Wire Tab Connector to #2 Wire.


5. Use these style wire tap for a fool-proof tap. The best wire taps money can buy, IMHO.


6. Crimp on Wire Tap onto Wire #1. Crimp far enough downstream to allow for the ease of Step #7 below.
FYI, I barely left enough room for mine, but for you guys, go further downstream (See Step #7).


7. Connect up Male Wire Tab to Wire Tap & Tape raw end of Wire #2.


8. Done, in 5 minutes time. Fogs w/CityLights Mod...
Whooot !!!!



Original Thread w/ Discussion: http://www.audizine.com/forum/showthread.php?t=124446