B8 Custom Steering wheel 12v connector?

[jxyjimmy]

Hi,
This is my first post on here. I couldn't seem to find anything about it but i need a 12 volt connection for the custom steering wheel I have gotten as it powers some addition things on the wheel. I do have the service manuals but I have no clue on how to interpret them and just need some help in general. I was mainly wondering what pins i could use for it or if anyone could send me any videos or anything on how to install something similar.
Thank you for any useful infomation

[Smac770]

When you look at the 12-pin yellow connector for the airbag harness to the coil spring, the top row of pins 1-6 should have the horn and the two airbag igniters. So don't touch any of that. The second row should have three wires, which you should see pass through to the connector to the right button unit. One is LIN bus, one is ground, one is voltage (I assume 12v). So that's your one wire for some free voltage. But as to how much extra power you can pull through that line, ....

[jxyjimmy]

I am assuming that it wouldnt be too much current to be honest since its only powering a couple leds