E-Brake Cable Placement for Voshmods Rear BBK with Air Ride

[bigboost3]

I am trying to see if anyone else has had this problem and could help me out.

I recently installed a full 18z brake set up on my b6 avant. I used the Voshmods kit for front and rear. The Issue I am having is with the placement of the e-brake cables. I followed the instructions that come with the kit to route the e-brake lines but with the voshmods set up it not really meant for car with an air ride set up and I have a problem with the e-brake lines rubbing against the axle boot.

Was wondering if any one else has ran the rear voshmods kit on there cars with air ride and what you did about the routing of the e-brake cables. Any good insight would be helpful and greatly appreciated.

Thank you.

[prizmatik]

I too have this same issue after my recent install. I also have air bags. I currently have the cables disconnected so the bags aren’t damaged. Did you find a solution to this problem?

[Turbavanttro]

Would a longer ebrake cable solve the rubbing problem? I know when I installed my rear BBK, I swapped the OE ebrake cable for OEM B7 RS4 or S4 cables since they are a little bit longer. Apologize in advance, it's been so long since I did the brakes I don't recall off hand if I used RS4 or S4 cables.