Audizine - An Automotive Enthusiast Community

Results 1 to 10 of 10
  1. #1
    Junior Member One Ring
    Join Date
    Dec 08 2021
    AZ Member #
    651321
    Location
    PL

    Q5 2009 right DRL not working

    Guest-only advertisement. Register or Log In now!
    There is no voltage to the headlight on pin 12, the blue-red cable.
    it is probably a PWM led power supply.
    Does anyone know where I can find the other end of this cable?
    or what could be the reason for the lack of voltage in the right lamp

    edit

    The lights are powered by the CECM/bcm module.
    Fault codes:
    02895 - Supply Voltage for LED Module for DRL and Parking Light; Left
    012 - Electrical Fault in Circuit

    02897 - Supply Voltage for LED Module for DRL and Parking Light; Right
    012 - Electrical Fault in Circuit

    left drl works fine
    did anyone have a similar problem?

    if I do not find another solution, I will pull the power from the left to the right but I do not know if the higher load will be good for the bcm module

    greetings
    Last edited by Bartlomiej; 06-30-2022 at 04:44 AM.

  2. #2
    Veteran Member Four Rings spijun's Avatar
    Join Date
    Oct 10 2010
    AZ Member #
    65508
    My Garage
    Audi Q5 2.0TFSI S tronic
    Location
    Sarajevo, BiH

    This was a common problem with the MY2009-2012 model, there is also a TSB to replace the control module for the DRL
    ----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

  3. #3
    Junior Member One Ring
    Join Date
    Dec 08 2021
    AZ Member #
    651321
    Location
    PL

    thanks for showing interest
    # 2020780/4 is for damaged drl module in lamp or led strip.
    in my case, the voltage does not reach the headlight
    can anyone tell me where the end of this wire is so that I can check the connection
    https://ibb.co/pQQZXcd

  4. #4
    Veteran Member Four Rings spijun's Avatar
    Join Date
    Oct 10 2010
    AZ Member #
    65508
    My Garage
    Audi Q5 2.0TFSI S tronic
    Location
    Sarajevo, BiH

    As far as I remember the BMC automatically shuts off the voltage when a problem occurs in one of the modules

    What you can try to replace the DRL modules, from the left to try to switch to the right
    ----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

  5. #5
    Junior Member One Ring
    Join Date
    Dec 08 2021
    AZ Member #
    651321
    Location
    PL

    Quote Originally Posted by spijun View Post
    What you can try to replace the DRL modules, from the left to try to switch to the right
    L module in L headlight works
    R module in R headlight doesnt work

    L module in R headlight doesn't work
    R module in L headlight doesn't work

    Drl module is different.
    by the way, errors were deleted several times, with no effect.
    Last edited by Bartlomiej; 07-01-2022 at 07:52 AM.

  6. #6
    Veteran Member Four Rings spijun's Avatar
    Join Date
    Oct 10 2010
    AZ Member #
    65508
    My Garage
    Audi Q5 2.0TFSI S tronic
    Location
    Sarajevo, BiH

    Quote Originally Posted by Bartlomiej View Post
    L module in L headlight works
    R module in R headlight doesnt work

    L module in R headlight doesn't work
    R module in L headlight doesn't work

    Drl module is different.
    by the way, errors were deleted several times, with no effect.

    at this point, I exclude that the module does not release the current because vcds shows voltage output to both lamps.

    I suspect a damaged cable.
    where can I find the bcm module?
    DRL is same , not is different, for left and right side S/N: 8R0907472B

    BCM or body control module will be located under dashboard on the driver side towards the center of the vehicle
    There are 3 different BMC modules, you need to know which one you have
    ----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

  7. #7
    Junior Member One Ring
    Join Date
    Dec 08 2021
    AZ Member #
    651321
    Location
    PL

    the BCM is part burned
    it's strange that it even worked

    spijun thanks for your help

    https://s9609.chomikuj.pl/ChomikImag...RBIzBOSnk&pv=2
    Last edited by Bartlomiej; 07-04-2022 at 06:18 AM.

  8. #8
    Veteran Member Four Rings spijun's Avatar
    Join Date
    Oct 10 2010
    AZ Member #
    65508
    My Garage
    Audi Q5 2.0TFSI S tronic
    Location
    Sarajevo, BiH

    Quote Originally Posted by Bartlomiej View Post
    the BCM is part burned
    it's strange that it even worked

    spijun thanks for your help

    https://s9609.chomikuj.pl/ChomikImag...RBIzBOSnk&pv=2

    I've never seen anything like it

    It was as if water was dripping on this electronics
    Attached Images
    ----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

  9. #9
    Junior Member One Ring
    Join Date
    Dec 08 2021
    AZ Member #
    651321
    Location
    PL

    Yes its looks like flooding water

    After replacing the bcm to another with the same numbers 8k0 907 063D from a4 b8, it shows an error:
    02095 - Component Protection Active

    the power steering and interior lighting do not work
    coding and adaptation with vcds

    what module should i buy

  10. #10
    Veteran Member Four Rings spijun's Avatar
    Join Date
    Oct 10 2010
    AZ Member #
    65508
    My Garage
    Audi Q5 2.0TFSI S tronic
    Location
    Sarajevo, BiH

    All Audi / VW modules have Component Protection, so they cannot be installed parts from stolen cars.
    This can be done by the dealer or ...................


    https://abrites.com/blog/when-life-g...ent-protection
    https://www.audiworld.com/forums/q7-...3001060/page2/

    Search on internet: CP removal
    ----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


    © 2001-2025 Audizine, Audizine.com, and Driverzines.com
    Audizine is an independently owned and operated automotive enthusiast community and news website.
    Audi and the Audi logo(s) are copyright/trademark Audi AG. Audizine is not endorsed by or affiliated with Audi AG.