Debadge

[WZ3R0]

Were you able to get the rear ring to sit flush with the curve in the trunk? How far above the trunk lip did you position the badge?

Mine does sit flush yes, Id have to measure it to tell you how far up it sits,

Before I took the original rings off I made a very elaborate tape template which allowed me to put the rings back exactly, it actually took longer to do that than removing the rings themselves.

[xliv]

Mine does sit flush yes, Id have to measure it to tell you how far up it sits,

Before I took the original rings off I made a very elaborate tape template which allowed me to put the rings back exactly, it actually took longer to do that than removing the rings themselves.

Do you know if there is a top and bottom for the rear rings? I saw a post saying there was a slight curve to one of the sides.

When I re-badged I used the outline from the adhesive on the original silver rings (which was still somewhat visible) as my template, but it's still not sitting quite as flush.