Audizine - An Automotive Enthusiast Community

Results 1 to 4 of 4
  1. #1
    Senior Member Two Rings
    Join Date
    Jul 24 2014
    AZ Member #
    267908
    Location
    PA

    Rerouting engine harness on single turbo setup

    Guest-only advertisement. Register or Log In now!
    So what all is involved or how do you go about rerouting the engine harness when your going single turbo ?

  2. #2
    Established Member Two Rings BDidz's Avatar
    Join Date
    Sep 18 2014
    AZ Member #
    283507
    Location
    Duluth, MN

    I ran mine under the coolant tank and across the top of the intake manifold.
    IMG_0062.jpg
    Blüberry

  3. #3
    Senior Member Two Rings
    Join Date
    Jul 24 2014
    AZ Member #
    267908
    Location
    PA

    No modulations has to be made to the harness it self tight?

    Did you heat wrap everything

  4. #4
    Established Member Two Rings BDidz's Avatar
    Join Date
    Sep 18 2014
    AZ Member #
    283507
    Location
    Duluth, MN

    I had to extend the two plugs that run down to the transmission and swap out the coolant level sensor plug for one that would fit the bubble tank. Other then that it was just rerouting/re-wrapping the entire harness.
    Blüberry



Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


    © 2001-2018 Audizine, Audizine.com, and Driverzines.com
    Audizine is an independently owned and operated automotive enthusiast community and news website.
    Audi and the Audi logo(s) are copyright/trademark Audi AG. Audizine is not endorsed by or affiliated with Audi AG.