AC Issues

[Whitee]

Just got my VCDS and scanned my car. Have a few pictures showing the codes. I replaced my A/C Pressure switch last night and the car still doesn’t blow cold at idle, only while moving.

Does this point to an electrical issue of some sort of I replaced the sensor and it’s still not working? Any input would be appreciated.

Apparently I can’t post a link with the new iPhone .

Two codes 00256 Implausible Signal to AC Pressure Sensor

01592 Air Quality Sensor No signal/Communication

Here is the information:


Address 09: Cent. Elect. Labels: 8K0-907-063.clb
Control Module Part Number: 8K0 907 063 P HW: 8K0 907 063 P
Component and/or Version: BCM1 1.0 H25 0380
Software Coding: 26001091063CAF010000080300003D0D4F1C52080001016100 0000
Work Shop Code: WSC 06325 123 12345
VCID: 3C21375D16620AB782D-8068
4 Faults Found:

03020 - Local databus 2
012 - Electrical Fault in Circuit
Freeze Frame:
Fault Status: 01101100
Fault Priority: 2
Fault Frequency: 96
Reset counter: 195
Mileage: 155360 km
Time Indication: 0
Date: 2018.09.09
Time: 20:24:00

00256 - A/C Pressure/Temperature Sensor (G395)
004 - No Signal/Communication - Intermittent
Freeze Frame:
Fault Status: 00100100
Fault Priority: 3
Fault Frequency: 3
Reset counter: 234
Mileage: 155372 km
Time Indication: 0
Date: 2018.09.10
Time: 09:48:00

01592 - Air Quality Sensor (G238)
004 - No Signal/Communication - Intermittent
Freeze Frame:
Fault Status: 00100100
Fault Priority: 3
Fault Frequency: 1
Reset counter: 234
Mileage: 155372 km
Time Indication: 0
Date: 2018.09.10
Time: 09:48:00

01592 - Air Quality Sensor (G238)
008 - Implausible Signal
Freeze Frame:
Fault Status: 01101000
Fault Priority: 3
Fault Frequency: 1
Reset counter: 234
Mileage: 155372 km
Time Indication: 0
Date: 2018.09.10
Time: 10:12:00


Address 08: Auto HVAC (8T1 820 043 AQ)

20:04:30
ERROR Refrigerant Pressure (G395)
3.0 Compr. Shut-Off Request
19.0°C Outlet Temp. Evaporator (G263)
ERROR Air Quality Sensor (G238)
ERROR Refrigerant Signal

From my understanding, if the sensor reads below 1.8Bar than the system throws a fault. Could getting the system refilled take care of this, or is it def related to wiring? I noticed on my old sensor it had white residue on it which leads me to believe it was leaking....





Sent from my iPhone using Tapatalk