Jhm lightweight flywheel ( 2008 prototype)

[Jigz13]

I recently bought the flywheel and clutch from another member. The mechanic I had working on my car was concerned that oem had 117 outer teeth and jhm had 115 and may jam the starter. After reasearching for almost a week I finally found what it was, confirmed by jhm. Its a prototype from 2008 1 of 5 made. The flywheel matches perfectly to the crankshaft and bolts up. I was told it won’t jam the starter but my clutch job was done before I found out this info. At $70 an hour I’m not going to install till clutch is bad which could be a long time. The friction liner has been modified to fit as the new design liners have differnt mounting points. Any offers will be considered.

- - - Updated - - -



- - - Updated - - -



- - - Updated - - -



- - - Updated - - -

[Jigz13]

[Jigz13]

Bump