traffic jam assist

[itskeyes]

Over on the a4 forums, there is a post about traffic jam assist coding now. Anyone try this yet? Going through it, there are some settings such as emergency assist setting to installed and emergency steer assist activated that are worrisome. Here's the coding (direct paste) (skipping HUD because car doesn't have hud):

Control unit: 13 Adaptive Cruise Control
Long Coding:
Assistent_for_traffic_hold_up -> activated
Traffic_jam_assistant_in_car_menu -> activated
Traffic_jam_dependent_linear_tracking -> activated
Driveaway by triggerleaver -> activated
Auto driveaway after short stop -> activated
Auto driveaway by pretrigger -> activated
Curve_assistent -> activated
Dense_traffic -> activated
Emergency_assist ->installed
Emergency_steer_assist -> activated

Note – some of these were already activated – I assume they are part of the stop & go function of the ACC.

Adaptations:
Nil

Control Unit A5: Front Sensors Driver Assistance System (Enter Security Code: 20103 before coding)
Long Coding
STA -> coded

Adaptations

Nil

Control Unit 44: Steering

Long Coding

Heading control assistant -> active
Traffic jam guidance assist -> active

Adaptations

Nil

Control unit 5F: Information control unit (Enter Security Code: 20103 before coding)

Long Coding

Nil

Adaptations

Fahrzeug funktionsliste bap2 generation erweiterung:

Front_traffic_assist_0x41 -> activated
Front_traffic_assist_0x41_msg_bus -> terminal 15

Vehicle configuration:

Control unit 5F: information control unit (20103 code)
Adaptations:

VZA pro: On

[larsmate]

Over on the a4 forums, there is a post about traffic jam assist coding now. Anyone try this yet?

I have it enabled on my FL S3 and love it. Can't be programmed with VCDS as the camera module needs updating with a different parameter set. This can be done with Vag CAN Pro (VCP). If you have access to VCP then you may be able to get it enabled via a remote session with the guys who have done the hard yards on figuring it out - here.

[itskeyes]

I have it enabled on my FL S3 and love it. Can't be programmed with VCDS as the camera module needs updating with a different parameter set. This can be done with Vag CAN Pro (VCP). If you have access to VCP then you may be able to get it enabled via a remote session with the guys who have done the hard yards on figuring it out - here.

There's a guy in virginia that has a guy who is enabling his car for Traffic sign recognition, i'll see his guy can also do this as well.

Thanks for the information.

[jon-stuver]

There's a guy in virginia that has a guy who is enabling his car for Traffic sign recognition, i'll see his guy can also do this as well.

Thanks for the information.

Can you check on activating the automatic high beams for pre face lift vehicles?