FL RS3 Track Setup

[FuzzyHat]

Good morning,

I was starting to do some research for a possible track setup later this summer. I was wondering what everyone is running and some details about their setups. What I'm looking for is a possible mix between dragstrip and road course / auto-x setups. Post your setups!

Information Needed:

• Wheels (Diameter, Width & Offset)
• Tires (Brand, Model & Size)
• Suspension Mods (Lowering Springs, Sway Bars, Sub-Frame Mounts, etc)

[Ethernaut05]

Yesss soooo need this thread. Need to know what psi to start a track day w OEM wheels and rubber, what drive modes and what do folks do with traction control?


Sent from my iPhone using Tapatalk

[sciblades]

Granted I'm running a ttrs it is essentially the same platform.

I am running

AP Racing Radi-CAL Competition Brake Kit (Front 9660/372mm)

Ferodo DS1.11 front pads and ds2500 rear pads

Spiegler front and rear lines

Castrol SRF fluid

Nuespeed 18x9 et45 wheels

Nitto NT-01 245 40 R18

And of course Unitronic stage 1+

I track the setup above it runs 10.9@125 and handles sebring with ease, I want camber plates and a stronger rear sway bar. Would love for audi sport to release the rear cross brace and wing but I wont hold my breath.

For drag racing I drop my pressures to 32psi cold.

For lapping I keep my fronts at 39 cold in front and 33 cold in the rear, my front tires can go up to almost 51psi at the end of the session. IMG-20180429-WA0019.jpeg20180428_070012.jpeg

Sent from my SM-N950U using Tapatalk