
Originally Posted by
Terry.Reese
So far no more codes, not even the bank 2 to Rich code.
Sent from my XT1650 using
Audizine mobile app
Well....
Just changed out my TB, had some issues getting it to do an alignment on block 060 on VCDS, finally got it done, these were the codes before it was done. Solenoid is not an issue as I have replacements that are being added. 034 mounts. Going to keep an eye on it after this test, once the test completed, less rough idle and a bit punchier.
4 Faults Found:
17985 - Right Engine Mount Solenoid Valve (N145) P1577 - 004 - Open Circuit
17987 - Throttle Actuator (J338) P1579 - 001 - Adaptation Not Started
17951 - Angle Sensor 1 for Throttle Actuator (G187) P1543 - 002 - Signal too Small
17580 - Angle Sensor 2 for Throttle Actuator (G188) Signal too Low P1172 - 002 - Readiness: 0110 1101
Considering replacing ECU and updating ground wire from battery.
Bookmarks