Originally Posted by fmzip
One Audison AP8 installed. Huge difference in mid bass, much tighter and much more accurate than the stock B&O. The tradeoff is the AP8 has less volume output in comparison to the stock speaker. This has been consistent with each speaker swap. It's obvious when you look at the quality of the stock speakers, you could drive them easily, there is nothing to them.
Audison offers a one inch tweeter in this series as well, an AP1. Think I am going to order a pair to see how they sound in the front sail panels.
http://www.audison.eu/index.php?page=product&id=55
Still need to tweak the mount I fabricated to get the door panel back on. For reference, I used two 8" rings which are 3/4" thick and sandwiched them together. I mounted those to a plastic ring I made from a cutting board which is about 1/2" thick. Ideally, if I had a slightly thinner piece of plastic, it would have made my life a little easier. This speaker is right near the door panel without much room to work with.
Audison offers a one inch tweeter in this series as well, an AP1. Think I am going to order a pair to see how they sound in the front sail panels.
http://www.audison.eu/index.php?page=product&id=55
Still need to tweak the mount I fabricated to get the door panel back on. For reference, I used two 8" rings which are 3/4" thick and sandwiched them together. I mounted those to a plastic ring I made from a cutting board which is about 1/2" thick. Ideally, if I had a slightly thinner piece of plastic, it would have made my life a little easier. This speaker is right near the door panel without much room to work with.
Not trying to be critical, but the picture above looks rather "ghetto". Looking to see if there is a better option e.g. reuse the stock speaker surround or maybe 3D fabrication
Reply With Quote
Bookmarks