Been working on my 'modified' jhm modified intake manifold for a few weeks and will be buttoning it up this weekend. Going to make some 'power gaskets' aka insulating gaskets for my throttle body elbow from some high temp high pressure graphite gasket material I have laying about from a job that required us to make some gaskets for a boiler door. My question for the community, is dose anybody want a set of power gaskets for their TB to elbow and elbow to intake? I have enough material for two other sets. BTW, yes I do realize this is probably overkill, but hey heat is my intake charge's enemy.
Reply With Quote
Bookmarks