Fluidampr vs. Stock Crank Pulley swap questions

[Cooper993]

Now that my car hit 50K miles, thinking of replacing the crank pulley as a proactive measure.

Don't want to go over-sized or solid pulley so I either get stock or Fluidampr.

However, looking at the Fluidampr site, it's unclear to me if they even make a stock sized pulley for our cars. If they do, which part number would it be (651211)?

If going with stock, there are many brands out there, ranging in price from $200 to ~$400 for Audi brand. Any recommendations on what to avoid/get?

Thanks

[MugelloB7RS4]

Now that my car hit 50K miles, thinking of replacing the crank pulley as a proactive measure.

Don't want to go over-sized or solid pulley so I either get stock or Fluidampr.

However, looking at the Fluidampr site, it's unclear to me if they even make a stock sized pulley for our cars. If they do, which part number would it be (651211)?

If going with stock, there are many brands out there, ranging in price from $200 to ~$400 for Audi brand. Any recommendations on what to avoid/get?

Thanks

Im not sure Fluidampr make a pulley for the supercharged 3.0L V6, as far as I know they only had listed the 30V engine which was a previous 3.0L NA motor. Someone correct me if I'm wrong, but I don't think its available.

[Dippy]

Correct p/n is 651201

[B18b1ex]

Now that my car hit 50K miles, thinking of replacing the crank pulley as a proactive measure.

Don't want to go over-sized or solid pulley so I either get stock or Fluidampr.

However, looking at the Fluidampr site, it's unclear to me if they even make a stock sized pulley for our cars. If they do, which part number would it be (651211)?

If going with stock, there are many brands out there, ranging in price from $200 to ~$400 for Audi brand. Any recommendations on what to avoid/get?

Thanks

The Fluidampr without the sleeve is stock size and bolts right up. Also nice when you decide to tune just grab your preferred sleeve angle add.

Best wishes.


Sent from my iPhone using Tapatalk

[Dutch_A6]

They do, I have 1 on my 2012 A7.

Sent from my Pixel 5 using Tapatalk

[RoofRails]

Now that my car hit 50K miles, thinking of replacing the crank pulley as a proactive measure.

Don't want to go over-sized or solid pulley so I either get stock or Fluidampr.

However, looking at the Fluidampr site, it's unclear to me if they even make a stock sized pulley for our cars. If they do, which part number would it be (651211)?

If going with stock, there are many brands out there, ranging in price from $200 to ~$400 for Audi brand. Any recommendations on what to avoid/get?

Thanks

I know you say you don't want a overdrive pulley but the future you may want a power bump down the road. You don't see these things hit the classifieds too often.

https://www.audizine.com/forum/showthread.php?t=936708

Sent from my SM-N986U using Audizine Forum mobile app

[PenttisHSR]

As regards a stock replacement, I went with Febi bilstein same as OE at less than half the price from Audi.
Part No. 32196

Link for spec....... https://partsfinder.bilsteingroup.co...+kW+%2F+333+hp