RS6 6MT swap w/ ttv flywheel

[Wide-66]

Anyone ever run one? I believe the reason my car wont run is improper machining of the tone ring portion of the flywheel.

[AudiTechS4]

why do you think that ? what faults are you getting ?

[Wide-66]

So im getting a couple cam correalation codes. The timing belt side is dead on. I believe this to be because the tone ring is machined wrong in relation to tdc and the cps. When I installed it the only way all 10 bolts lined up the blank in the flywheel tone ring landed just past 1 o clock at tdc looking at the back of the motor. It should in my opinion the blank should land around 10 o clock at tdc. This would match it up to the 01e cps spot.

Other info i gathered was that when the flywheel is in that 1 o clock position cylinder 4 is at tdc. So its not completely randomly machined.

I just want to find someone who i can reference their install of the ttv flywheel to figure out if the flywheel is indeed correct or if a tune is needed to adjust something with the timing.

Also TTV was a bit useless in answering my question. They said they have sold a ton of them over the years so its fine.

[Scotty@Advanced]

I have one here as well and the cutout on the TTV flywheel is about 50 degrees off of where the RS6 flexplate is. Looking at both transmission the cutouts should be very close to each other.