Vent Removal Help

[Borg54]

Anyone know how this rear vent comes out?




I think it is just held in place with tension clips but before I go breaking something I want to make sure there isn't anything I need to disconnect or remove first. Thanks for any help.

[eurodaddy]

Yes it is just clips behind. Get a plastic removal tool and slip behind the aluminum trim. Probably one on each side. They are a little tough but it will pop out.


Sent from my iPhone using Tapatalk

[Borg54]

Yes it is just clips behind. Get a plastic removal tool and slip behind the aluminum trim. Probably one on each side. They are a little tough but it will pop out.


Sent from my iPhone using Tapatalk

Thanks. Do you know if they are on the sides or bottom where specifically?


Sent from my iPhone using Tapatalk

[tenspeed]

Here's a eBay listing of the console with no vent. You might see from the pictures where the clips attach.
http://www.ebay.com/itm/2014-13-14-A...tUtIn5&vxp=mtr

[scott99c2]

I just did it. You need to put a hook tool inside the vent and pull one side. The factory manual shows a special tool, but any hook tool will work.

If I get a chance I'll take a picture later today.

[Borg54]

I just did it. You need to put a hook tool inside the vent and pull one side. The factory manual shows a special tool, but any hook tool will work.

If I get a chance I'll take a picture later today.

Thanks Scott! I actually messed with it for a while yesterday and finally got it out. I really appreciate you following up


Sent from my iPhone using Tapatalk