upper vacuum lines B6 S4 4.2

[Terry.Reese]

Looking for the vacuum lines for my S4, mainly the end pieces that have the u curve rubber end, even if those are all you have I am interested as I can fabricate new hoses, just really need the curved hose ends if anything else..

Thanks



The curved tube I am looking for is this one below. disregard what it is attached to as i could not actually find the correct hose but this is the same type of bend I am describing.

[VroomTT]

Any chance you know the exact size/gauge of these vacuum tubes? I've mended mine up in a couple spots and have been putting off replacing them for too long at this point...

My plan is to just find the right sizes and replace as much as I can. Thanks

[Terry.Reese]

5/32 I think or 3.5mm i did the same, but with the nipples being directed at the valve covers it is a bit hard to get a hose in there without kinking it, that is why I am looking for the U parts, I can fabricate something for it them, I even tried copper pipe and bent it, but to much air escaping.