Attempting a clutch change.

[Hooblah]

Hey guys, just been reading through the clutch replacement diy on audirevolution and the guy uses an engine support beam to hold the engine while the subframe is off. I don't have one of these and neither do I wish to spend the money on something I'm only going to use once.
So I was wondering, can I just use a jack or axle stands under the sump to hold it up? I could possibly make one but it seems like more effort than its worth. Any other ideas?

[BCsniper]

I've done it numerous times without supporting the motor. You'll probably need to lower the subframe a bit to get those 3 bottom bolts, afterwards just make sure to tighten it back up when you get the trans off. The motor mounts and snub will keep the engine in place.

[Hooblah]

Cheers mate.