2001 B5 S4 Part Out (Nogaro)

[FlyboyS4]

In the process of parting out a Nogaro B5 S4. (Since I'm in the process not everything will be able to be shipped immediately).

I'm adding parts to the page at the link below, but feel free to email me with requests.

The block and heads are not for sale, but most of the stuff that attaches to the engine is likely something I will sell. (I'm swapping engines with another S4)

Parts List

[chuckhet]

Where are you located?

[FlyboyS4]

St. Louis

Gateway to the west, but not close to any S4 owners that need parts.

[Mr.Avant]

Looking for a 2.7t throttle body, measuring 70mm. Willing to sell? Ship to Canada? Pm me.

Sent from my SM-G920W8 using Tapatalk

[155VERT83]

Jeff,
I'm converting a 2.8L to 2.7t.
Add'l parts wanted:
1. Horns (both sides of SMICs)
2. AC hoses (all hose from pass side plenum to compressor)

[Rusty24]

If your retractable cup holder works I'll take it when it's available.

[FlyboyS4]

If your retractable cup holder works I'll take it when it's available.

Unless it is just stuck it does not appear to be working.

[rdcyclist]

Senchu ah pee em...

[Noggyguy]

My car is in Missouri and in need of turbos

In the process of parting out a Nogaro B5 S4. (Since I'm in the process not everything will be able to be shipped immediately).

I'm adding parts to the page at the link below, but feel free to email me with requests.

The block and heads are not for sale, but most of the stuff that attaches to the engine is likely something I will sell. (I'm swapping engines with another S4)

Parts List

[FlyboyS4]

My car is in Missouri and in need of turbos

What are you looking for K03, K04, K04-hybrid?

[dootie]

Do you have interior parts available? Looking for in particular the upper b pillars for the driver and passenger. Thanks

Sent from my LG-H815 using Tapatalk

[FlyboyS4]

Do you have interior parts available? Looking for in particular the upper b pillars for the driver and passenger. Thanks

Sent from my LG-H815 using Tapatalk

Yes, I have those, not yet removed.

[dootie]

Pmd

Yes, I have those, not yet removed.

Sent from my LG-H815 using Tapatalk

[Audi9]

Are those tte 550s available?

[bagged_s4]

Sent you an email about passenger fender

Sent from my SM-G920P using Tapatalk

[FlyboyS4]

Are those tte 550s available?

Yes.

[Audi9]

Pm sent

[S4KARL]

Does the car have coilovers by any chance?

[FlyboyS4]

Yes. They're dirty, and still on the car, but the springs are H&R. I can make out H&R on one of the tubes, but I haven't pulled all of them off to size them up.

The springs look to sell for around $225-$250 alone, and since I don't know the mileage on the shocks, I'd be willing to sell the whole suspension setup for $350 plus the shipping cost.

[Strzyzowiak]

hood still for sale ?can you ship to 02896?

[FlyboyS4]

hood still for sale ?can you ship to 02896?

It is, but the logistics involved with shipping it are ugly. It's huge and heavy and would need to be well protected. I can give you the measurements to look into shipping options, but from what I have found so far the only cost effective way for someone to get it may be picking it up.

[quattEUro]

could i grab the trim piece for the ashtray please!

[FlyboyS4]

could i grab the trim piece for the ashtray please!

You're referring to the piece that attaches to the front?

[FlyboyS4]

Making this cars sweet no-name brand K04's available. In general they look ok, though there is one blade tip with a little bend to it, aside from that the blades are in good shape. No unusual play. I don't know how long they've been on the car, if they went in with the clutch then they probably have about 3k miles on them. Only drove the car briefly so I can't say much about them from the driver's seat, drove fine for when I did drive it. $400 shipped. Or grab the SRM upgraded K04 CHRA's ($299 a piece) to install in these housings.

[xalents23]

Great seller, got my parts as described.

[Ephry73]

Awesome deal.


Sent from my iPhone using Tapatalk

[quattEUro]

You're referring to the piece that attaches to the front?

yes sir.

[SFourPlay]

Do you have interior pieces? If so, I am in need of the driver side interior air vent and housing.

[FlyboyS4]

yes sir.

Ok, I'll remove it shortly.

Do you have interior pieces? If so, I am in need of the driver side interior air vent and housing.

Yes, I'll take it out and we can arrange shipping.

[quattEUro]

and actually, i could use the center drivehaft as well if youve still got it. Manual correct?

[FlyboyS4]

and actually, i could use the center drivehaft as well if youve still got it. Manual correct?

Yes. I haven't taken it off yet, but it is available.

[Audi9]

Received my parts. Awesome seller

[dos]

I picked up the drivers seat from the seller last Friday. Great condition and great seller, even waited for me while I was running late.

[Michael_b5_s4]

Got my door in perfectly packed up! Thanks

[quattEUro]

Yes. I haven't taken it off yet, but it is available.

in that case ill take the center driveshaft, ash tray trim, and shifter surround plus boot

[Ephry73]

Wondering about the K04s.


Sent from my iPhone using Tapatalk

[JordanBetch]

Local to STL, 63303. Have a metal thermostat housing? And what's the status of the RS4 grille?


Sent from my iPhone using Tapatalk

[FlyboyS4]

Local to STL, 63303. Have a metal thermostat housing? And what's the status of the RS4 grille?

I haven't delved far enough into the engine to determine if it has a metal housing, I may use the engine myself. RS4 grille is available still.

[JordanBetch]

I haven't delved far enough into the engine to determine if it has a metal housing, I may use the engine myself. RS4 grille is available still.

Pm'd


Sent from my iPhone using Tapatalk

[MARKHONZ]

Im looking to buy the front drivers side axel. If the CV boot is in proper condition I would be interested, thank you!