Anyone have this part #?

[Royal769sr]

https://cloud.tapatalk.com/s/57c870eb...01_003613.jpg?

It's the taper roller bearing that goes on the 1-2 shaft :(


Sent from my SM-G930T using Tapatalk

[kdf8454]

http://advancedautomotion.com/shop/p...roducts_id/194

[xalents23]

Try calling up JHM Motorsports they might have some laying around. Whoops, you needed the entire bearing part number.

[Royal769sr]

Thanks man. I am pretty sure it is made by (Temmken) I think I have it spelled right. But I have seen the as low as 40 bucks or so but couldn't tell if I had the correct one. Thanks for the link

Sent from my SM-G930T using Tapatalk

[rpallen85]

Thanks man. I am pretty sure it is made by (Temmken) I think I have it spelled right. But I have seen the as low as 40 bucks or so but couldn't tell if I had the correct one. Thanks for the link

Sent from my SM-G930T using Tapatalk

Timken (typo I'm sure but wouldn't' want that to keep you from finding one)

[Royal769sr]

Thanks I realized after lol

Sent from my SM-G930T using Tapatalk

[rpallen85]

In the picture your inner race is missing and the cage is a little beat up, what happened?

[Royal769sr]

Well. I was being stupid after a few hours in 110 degree garage I started to get careless. I didn't measure the pipe when I cut it from scrap piping I had laying around and it was about 1/2 in too long.
So I figured that after taking it out of the boiling water I would have enough give to slide it on. Wrong. And I tried tapping it on with the pipe.

It went on but it started to feel loose and out of nowhere it just fell apart. I also found the problem with my second gear.

(Not the collar)
FB_IMG_1472687235208.jpg

Sent from my SM-G930T using Tapatalk

[rpallen85]

holy obliterated synchro!

[zillarob]

Im sure I have a used one kicking around if you cant find one.


Boiling water? Check this out

[zillarob]

Oh, and save the inner race from the busted bearing- you can use it to push the replacement on.
I cut a slot through one side with a cutoff wheel so I can pry it open with a screwdriver and slide it off easily.

[rpallen85]

What? You don't have a $3000 induction bearing heater?

The oven works too fyi. A little EZ Bake

[zillarob]

We have one of the miniductor contraptions, but I aint getting my balls anywhere near that devilry

Always had an old hot plate and pan of oil to heat stuff.

[Royal769sr]

Thanks Zilla! I may have found one from an audi parts dealer. But I will keep you posted. Thanks for the idea of using the collar

Sent from my SM-G930T using Tapatalk

[Royal769sr]

Im sure I have a used one kicking around if you cant find one.


Boiling water? Check this out

Just saw this video. Wow

[zillarob]

Watch some his other vids, dude does some cool stuff and is funny as hell