CTS Intercooler Install Questions

[gilber33]

Hoping to get some guidance from those who have installed the CTS intercooler, or if you haven't, maybe you can still chime in.

So far everything is going OK. My one hang up right now is the pressure sensor that I removed from the smic that now gets installed on the cold side piping is not anywhere close to fitting. Am I missing something here?

[MetalMan]

That MAP sensor hole looks like it's for a B5...
B5 MAP sensor:
https://www.ecstuning.com/Audi-B5_A4...essure/ES9611/

B6 MAP sensor:
https://www.ecstuning.com/Audi-B6_A4...sure/ES275345/

There is a spacer/grommet that is used to take up the difference. It's the same part I'm using on my B5 to fit a 3bar MAP sensor.

[gilber33]

That MAP sensor hole looks like it's for a B5...
B5 MAP sensor:
https://www.ecstuning.com/Audi-B5_A4...essure/ES9611/

B6 MAP sensor:
https://www.ecstuning.com/Audi-B6_A4...sure/ES275345/

There is a spacer/grommet that is used to take up the difference. It's the same part I'm using on my B5 to fit a 3bar MAP sensor.

Do you have any info on where to find that grommet?

Thank you!!

[MetalMan]

http://www.idparts.com/bar-map-sensor-g31-p-655.html
It's the little grommet in the picture. These guys will sell it separately, I got mine from them for $8 shipped.

Another source, but $9 shipped:
http://www.fixmyvw.com/map-sensor-bung-grommet/