Paddle shift issues after steering wheel replacement

[ChoppaJon]

I just replaced my heated 4 spoke steering wheel on my 12 A7 with a 15 RS7 3 spoke wheel. Everything works fine with the exception of the paddle shift. I am not sure if I need to Vag-Com it and change a setting or not. If anyone could offer some guidance I would appreciate it.

[mjfloyd1]

Did your 4 spoke have paddles?

[ChoppaJon]

It did not

[mjfloyd1]

VCDS (VAGCOM) go to steering wheel module then byte2, then check bit 5

[ChoppaJon]

Thank you very much

[mjfloyd1]

No problem.

I corrected my last post so make sure steering wheel module then byte 2 and check bit 5

[ChoppaJon]

Thank you!!!

[ChoppaJon]

I tried what you suggested however there is no Bit %. Instead there is a Bit 4-5 where there are (3) option. The original code was for the 10 MFL and I changed it to 30 MFL with Tiptronic. For some reason the paddles are still not activated. Do you have any other suggestions?

Thanks

[ChoppaJon]

Got it to work