Rear endlink bolt

[brandingo]

While doing my rear brakes I have found the source of the clicking from my rear end.... I have lost the sway bar end link bolt which holds the sway bar in place!
I need to know the thread and length of the bolt in this place. I found out it is a 16mm head from another forum thread but not the other details. Thank you!

[JDillon15]

for some reason m14 x 1.5 comes to mind. Did you lose all of them? I know I lost one, took one of the remaining off to the hardware store and bought a replacement.

[brandingo]

for some reason m14 x 1.5 comes to mind. Did you lose all of them? I know I lost one, took one of the remaining off to the hardware store and bought a replacement.

ah, you're a thinker... i was just hoping i could snag one from work tomorrow and not go through the hassle of taking the other side off

[Ringsby4]

ah, you're a thinker... i was just hoping i could snag one from work tomorrow and not go through the hassle of taking the other side off

Gee,if you'de only asked yesterday I could have measured them,had them in my hand.Defin. 16mm head and when I removed these to fit my 034 bar earlier and yesterday dropping my car, they seem crazy short for the application and hard to access ( as you know ) ...

[Okedokey]

Pretty sure theyre M10 x 20

[Mindstorm20]

I know on the 034 endlinks they're M10x20. I didn't use any loctite my first time around and lost one as well.

[ECS Tuning-Audi]

OEM size is M10X18

Click HERE to order or for more information


Jason

[milk]

Can I use a M10x20 with OE end links and 034 rsb?
And what would be the pitch? 1, 1.25, 1.5?

Ordered new end links as one had the nut break off. Don't have access to pull other end link and check at the moment.

[milk]

For future reference: new OE end links came with all new hardware. Endlinks to body, and endlinks to RSB (3 bolts, 1 washer)