Abs module coding

[RagtagXMASTER]

So i did the b5 s4 upgrade to my 01 a4. I read around that you may need to recode the abs module when you do this. I have not and my car stops fine but my pad warning indicator has been on ever since. Am i suppose to code the module for s4 calipers and pads.

Also i dont know if its related but wenever i apply the brakes at low sppeds under 5mph to stop it squeals a lot. I have aquabono bads and brembo blank rotors.


Sent from my iPhone using Tapatalk

[Bordom]

What? I've never heard of such a thing.

Did you bed the rotors/pads properly?

Everything graciously mispelled by Android

[RagtagXMASTER]

I guess its possible to send a different bias from the module to the caliper. I did break the pads in properly and wats weirder is that it only squeals on my first stop.


Sent from my iPhone using Tapatalk

[bhusted]

I have HP2 calipers on my A4 and did no special coding to the ABS. I have no issues with mine and the and the pad warning light isn't on. I think your squealing must be from the pad/rotor combo. The warning light harness goes though the ABS harness and I've found that the wires are quite fragile. Inspect the plugs for failed wires.

[crazyquik22023]

Make sure the plug is in all the way on the pad connector. As they get old they tend to break and not seat properly.

[RagtagXMASTER]

Will do i might make a bypass soon


Sent from my iPhone using Tapatalk