SQ5 Wheel Specs...

**iconoclast** · 01-12-2016 05:48 PM

Can anyone on here tell me the complete specs on the SQ5 21" wheel?

P/N: 8R0601025AM

21 X 8.5 ET 33

What is the bore?

I am guessing the PCD is 5x112 but would like to confirm that as well.

**JayCar** · 01-12-2016 06:16 PM

See if this helps. I don't see that it lists the bore, but you're correct on the PCD. http://www.partsbase.org/audi/audi-q...ud-8r0601025am

**B-Time** · 01-12-2016 06:58 PM

Should be 66.6. Older Audis are 57.1.

**Mops@Nemesis** · 01-12-2016 08:08 PM

66.6 and 5x112.

**iconoclast** · 01-13-2016 04:19 AM

Thanks for the help guys.

Will a 21x9 et25 have a poke effect? Ideally I want to land flush with fender and not a hair further.

**colby7** · 01-13-2016 08:29 AM

Originally Posted by iconoclast

Thanks for the help guys.

Will a 21x9 et25 have a poke effect? Ideally I want to land flush with fender and not a hair further.

I think the front wheels will poke 2mm, and the back wheels will be 5mm short of flush.

**iconoclast** · 01-13-2016 09:16 AM

2mm i could probably live with but i would need a 5mm-8mm spacer in the rear to even it out.

**Jimminez@Nemesis** · 01-13-2016 09:44 AM

Originally Posted by iconoclast

Thanks for the help guys.

Will a 21x9 et25 have a poke effect? Ideally I want to land flush with fender and not a hair further.

Curious, what did you find?

**Mops@Nemesis** · 01-13-2016 10:00 AM

You've seen mine. I'm at 9.5 ET27 front, and ET23 rear in this pic...

NO.-3989 by Audiyos, on Flickr

**colby7** · 01-13-2016 10:28 AM

Does anyone know the max ET we can run without running the knuckle?

**Jimminez@Nemesis** · 01-13-2016 11:26 AM

Originally Posted by colby7

Does anyone know the max ET we can run without running the knuckle?

It will depend on the tire selected as well but from what I've seen with someone running a 10.5 ET25 and having a few mm to spare, the space you have l is about 17mm further in compared to stock. So specs that give you that are (inside/outside difference from stock 8.5" ET33):
10.5" ET25 (33.4/17.4)
10" ET32 (20.1/18.1)
9.5" ET38 (7.7/17.7)
9" ET44 (-4.6/17.4)

So one could run lower offsets on the 9-10" wheels to obtain more clearance depending how far out/poke you want.

As Mops shows above, an 9.5" ET27 sticks out 18.7mm on the outside and 6.7mm on the inside.