Hi everyone i just got my vehicle back from the dealership. I am assuming they didn't charge it they had it for over 10 days. The car cranked quite a bit for a while before it started the battery percentage was 20% but it charged up to 100% under an hour. I did a VCDS scan this is the only thing that concerns me i am wondering if the battery needs to be coded or not. I don't know if it was every coded but i never had issues with it. If these codes are the result from being at a low voltage than that's a good thing . Does any know how to check if the battery is coded on a 2007 AUDI A6


Address 61: Battery Regul. Labels: 4F0-910-181.lbl
Part No SW: 4F0 910 181 E HW: 4F0 915 181 A
Component: J0644 BEM H12 0590
Revision: 00000000 Serial number: 00000000027224
Shop #: WSC 40322 403 54476
VCID: 23450907E2202306A91-8076

Subsystem 1 - Part No: 4F0 915 105 D
Component: von VA0 2605081815
Coding: 344630393135313035442056413032363035303831383135
Shop #: WSC 00000 512 00290

2 Faults Found:
02272 - Quiescent Current Stage 1
000 - - - Intermittent
Freeze Frame:
Fault Status: 00100000
Fault Priority: 7
Fault Frequency: 6
Reset counter: 255
Mileage: 183987 km
Time Indication: 0
Date: 2015.12.14
Time: 17:10:55

02273 - Quiescent Current Stage 2
000 - - - Intermittent
Freeze Frame:
Fault Status: 00100000
Fault Priority: 7
Fault Frequency: 3
Reset counter: 255
Time Indication: 0
Date: 2015.12.14
Time: 17:16:07