Any Help w/ PAC RP4-AD11

[jcm15]

Anybody have experience installing this product? I think it will be relatively straight forward once I have it in my hands, but I want to make sure before I dive into it. By my estimates, with my 2007 A4 w/symphony ii+, there will be a number of harnesses/wires not used on my install. What I'm not clear on based on pictures and lackluster instructions from PAC is what each harness is for. Can someone help inform me which harness goes with what in picture in this link:

http://www.autotoys.com/pics/RP4-AD11.jpg

Thanks in advance!

[Luis_Heineken]

the products from enfig are true plug & play and cheaper too.
EnfigCarStereo.com or call Christian at 201-490-5015

[jcm15]

I appreciate the plug and play, and would have gone that route had I realized it sooner but already bought the stuff and am not going to send stuff back and order all new stuff. But, the Enfig stuff is not cheaper. It might be worth the extra money, but it's over 2x as much for the necessary pieces. I am not afraid of a little soldering...

[Luis_Heineken]

i understand that, something like your problem happened to me but with the axxes aswc. it never works (lost $ ).

[jcm15]

After it was all said and done the PAC RP4 worked out perfectly. And I couldn't imagine how much harder it would have been to fit the radio with additional harnesses in back. It was a tight fit as it is, and I'm still not sure it's 100% as far back as it should be...

[Luis_Heineken]

you just hid all the stuff behind the a/c controls

[jcm15]

Yeah, tried that. Still not quite right.