Issues with Remote Windows Up/Down

[b0i]

So I coded my car to roll up and down the windows with the key fob about a month ago with a program called VAS-PC if anyone is familiar with that, I've had no issues with it whatsoever. But today I tried using the feature and now it is not working at all. This whole coding thing is very new to me and I can't for the life of me figure out why the feature no longer works. The only thing I know I've done within the last two days was put a new battery into my key fob, I don't think this would cause me to lose this feature but then again I could be completely wrong. I do know when i switched the battery I wasn't able to use the key fob until I used it in my ignition and then it was good to go again. If anyone can shed light on this it would be greatly appreciated!

Thanks,
Nick

[sa_seahawker]

Try putting key into ignition, turning on ignition and press buttons a couple times. Then manually roll down each window all the way down and then back up. I had similar problem after switching from a B6 to B7 remote. Couldn't understand it either because I swapped in the old chip.

If not then u may have to use VCDS to check the settings

[b0i]

Well I'm not sure where the issue was, but I did exactly what you said I was having issues with opening and closing the windows physically at the door lock as well. But after rolling my windows fully up and fully down a couple times and cycling the key they are back in working order! Thanks for the tips/trick!

[mccorkled]

I will have to remember this.