did my slave cylinder go out?

[im-audi]

So i was driving home last night and i was shifting from 3rd to 4th and i couldnt get it in 4th. so i slowed to go back to 3rd, couldnt do it. went all the way to a stop and i couldnt get it into any gear at all. So i turned off the car and i could shift through all the gears fine. i can only start it in neutral and cant shift to a gear. Its like im not even pushing in the clutch. My fluids are fine. when the car is off and i push in and out on the clutch i cant even hear the clutch clapping against the flywheel.
Anyone have any insite on this? slave? master? sensors?

[joe dub]

does the pedal return? is there fluid under the car

[Dutchsider]

Bleed the slave first

[im-audi]

does the pedal return? is there fluid under the car

yes the pedal return. no fluid under the car.

[im-audi]

Bleed the slave first

any good write ups on this?

[Dutchsider]

any good write ups on this?

Search, as always, is your friend.

http://www.audizine.com/forum/showth...-JHM?p=2997541

[4rings11]

This happen to me i could get it into gear if I pumped the clutch a couple times eventually I smoked my clutch and found when I replaced it the pressure plate fingers were messed up

[Eurotuned_A4]

He has a brand new clutchmasters fx400 and has been running it for a few months now so its highly unlikely that it's his pressure plate. Im assuming it's his slave, but as others have said I would bleed it first.