Post a random pic of your Avant thread!

[hardfive]

A bit dirty from a joy ride; been having an absolute blast with her as a bit of a last hurrah.

Sent from my SM-G973U1 using Audizine Forum mobile app

[Das Ponto]

Doggo Santa by Ryan Ponto, on Flickr

Went with our pups to pick up my new bike.

[sebvw]

Rando pic




Sent from my iPhone using Tapatalk

[shreddykrueger]

[Tai-Lun]

A break from the rain here... having some fun with the ol' point and shoot.

[sebvw]

A break from the rain here... having some fun with the ol' point and shoot.

Looks good!

Tell me more about your sideskirts, front lip and rear diffuser please


Sent from my iPhone using Tapatalk

[Tai-Lun]

Looks good!

Tell me more about your sideskirts, front lip and rear diffuser please


Sent from my iPhone using Tapatalk

Thanks!

Sideskirts and front lip are the OEM options we don't get here, I found the front lip in the UK and the sides I think came from Germany (both found on eBay) and are FRP/carbon fibre as the factory units are no longer available. Fitmet was excellent considering and you can just see the weave of the carbon on the side skirts at certain angles too. The rear diffuser is Maxton but I don't recommend it for a non-RS6 as none of the mounts will line up or even get close to lining up so it was a huge pain to get it even this close. Way too much money for what is essentially some plastic sheets cut and bolted together. They flex far too much for what they are just in passing if you bump into them, so I'm looking for something to replace the whole valence now.

[sebvw]

Thanks!

Sideskirts and front lip are the OEM options we don't get here, I found the front lip in the UK and the sides I think came from Germany (both found on eBay) and are FRP/carbon fibre as the factory units are no longer available. Fitmet was excellent considering and you can just see the weave of the carbon on the side skirts at certain angles too. The rear diffuser is Maxton but I don't recommend it for a non-RS6 as none of the mounts will line up or even get close to lining up so it was a huge pain to get it even this close. Way too much money for what is essentially some plastic sheets cut and bolted together. They flex far too much for what they are just in passing if you bump into them, so I'm looking for something to replace the whole valence now.

Thanks for the info dude!


Sent from my iPhone using Tapatalk