Driveshaft support bearing fix using 3M Windo Weld

[Aamaro1971]

I haven't had an issue since I fixed it in 2011. Inspected it last fall and it was in better condition than a stock bushing. The longevity is not an issue.

I would reccommend doing it as a preemptive maintence task.

I have done this fix and i must say it works. I couldn't find Windo Weld from 3M so i used the one from Berner®. I guess we can use any brand just as long as the carachteristics are the same. It took me like half an hour in the evening and i started using the car the next morning at 7. I drove for 900km that day with no problems whatsoever since then. I strongly recommend this fix. It is cheap and effective. TYVM Durf!!