Rewiring Oil Level Sensor

[ninjabmx64]

Does anyone have a wiring diagram for this sensor? A mouse ate through one of the wires right where they run into the back of the plug. I removed all three wires and now I can't remember which wire goes in which hole on the plug. Thanks.

[ridefastdietryi]

#1 i have the same problem right now.

[diagnosticator]

The oil level sensor is G266, T10a is a Brown 10 pin harness connector in the ECU box. The G266 Brown ground wire connects > G266 terminal 2, The Black/Red wire connects harness connector T10a terminal 2 <> G266 terminal 1, The Red/Green wire connects harness connector T10a terminal 9 <> G266 terminal 3.

[ninjabmx64]

Perfect. Thanks a million!

[shane_yank]

The oil level sensor is G266, T10a is a Brown 10 pin harness connector in the ECU box. The G266 Brown ground wire connects > G266 terminal 2, The Black/Red wire connects harness connector T10a terminal 2 <> G266 terminal 1, The Red/Green wire connects harness connector T10a terminal 9 <> G266 terminal 3.

I going to noob this up if you don't mind... :)

The above is jiberish to me, but apparently the wiring to my oil level sensor is damaged. The warning light came on the morning after I parked in a wooded area so I'm thinking a rodent might have attacked. Is it possible that you'd have a picture of this DIY or any kind of diagram that would help me locate the sensor so I can see if i can solder up the wiring?