Fitment issues?

[CheesmoS4]

I was looking into buying set of winter rims with the following specs :

18 x 8
5 x 112
ET 35

Will i have any fitment issues?!?1/

[Polo//S4]

You'll probably have to roll & pull the fenders. Good luck.

[CheesmoS4]

I wont have issues fitting these over the rotor and calipers?

[odhinnhrafn]

No, those will fit, all except for the most extreme spoke designs. I have a set of OZ's w/those specs on right now. No rolling of the fender or spacers needed.

[twinsnailsS4]

Assuming you are on stock rotors/calipers, no issues with the rotors. The calipers will depend on the spoke design of the wheel--what wheel is it? Also, unless you get fat/wide tires, you shouldn't have a rubbing issue or a need to pull the fenders, etc.

[KNaudi]

You'll probably have to roll & pull the fenders. Good luck.

No you won't. I run that size in the winter with 5mm spacers.

[CheesmoS4]

These are 18" DTM REPS... i want to put blizzacks on them since my stocks are boring me and i dont want to run my iforged senekas 19 during the winter time. They are really good deal right now so i was wondering if i would have any issues with these things i appreciate all your guys help!!!

[Skyler@Achtuning]

Will i have any fitment issues?!?1/

Caliper clearance depends on the specific wheel and the design of the spokes. Having an ET 35 offset is no guarantee that the brake caliper will not contact the back of the spokes. If possible, do a test fit before you buy and keep in mind that the caliper will extend further outwards when new pads/rotors are fitted.

EDIT *did not see the previous post when replying*

The Hartmann DTM wheels in 18x8.0" ET35 will clear the HP2 calipers no problem

[CheesmoS4]

This maybe a dumb question can i use the same lug bolts that i am using on my 17s with these rims or would i have to get ones that are longer?

[twinsnailsS4]

This maybe a dumb question can i use the same lug bolts that i am using on my 17s with these rims or would i have to get ones that are longer?

Longer ones by approx 10mm since the center of the wheel is now further out 10mm. Also, I don't know if reps use the same seated lug bolts--OEM are ball seated and many aftermarket are conical.