Hey guys,

Other than the classifieds, this is my first real post about anything so excuse me if I'm in the wrong section or I commit any other forum missteps lol. I was talking to a buddy from AZ awhile ago about his unique build and him maybe doing a post about it and I figured I would throw my car out there. I'm sure there must be others like my car out there, but up here in Canada, she's the only one I've seen for the last two years since I've had her on the road. Excuse my photog skills lol



Basically, I had the whole stage 3 setup in a narrowbody A6 for a long time as my daily and then some idiot here in downtown Toronto grazed the entire driverside and drove off while it was parked. Instead of spending money revamping a narrowbody, I figured why not throw the motor and 01e setup into a 4.2 widebody and make something unique?? The ultimate goal is to install my RS6 side skirts/bumpers to make it an RS6 lookalike with the 2.7T underneath... is this sacrilege? Lol any input would be appreciated on that, and rim choice bc I can't decide what to do on that front either :) once my RS6 wagon project is done next month this is the next thing up! Any questions about the build if someone wants to try it would be welcomed!

Even though she's my daily driver, as you'll see from the list below, she's still an ongoing project-- but she's as reliable as my golf lol with almost 180k miles on the odometer with 100 of those being at stage 3.

Specs:
2.7T stage 3 motor mated to 01E
034 stage 3 tune (previously had a stage 3 Daz Dillinger tune with 650ccs but I retired it once he passed rip)
rs4 Borg Warner ko4s
550cc injectors
RS6 icm delete kit from 034
Upgraded walboro fuel pump
Soon to be aluminum bi pipes
Fmic from JHM
Custom Kevlar stage 3 clutch (built by eurodrive in Burlington, Ontario)
3" stainless Straight pipes all the way with resonators (kept getting pulled over lol)
Full cayenne 18zl front brake package
Rear RS6 brakes/rotors (currently being installed)
Full 4.2 sportback interior (soon to be S6 alcantara seats with RS6 black alcantara interior )
RS6 speedo
Carbon fibre interior trim (haven't installed it yet)
RS6 skirts/bumpers coming after wagon project
Led tails
Perforated leather 3 spoke steering wheel

*** I can't remember anything else

Special thanks:
Huge thank you to Mat radman and Ryan squires at highcrest automotive in Barrie, Ontario who were the engineers behind the project and did most of the heavy lifting. Also a huge shoutout to Jeremy at 034 who was so cool, patient and informative with all the tuning and peripherals.

Thanks for taking a look and good luck with all your respective dream machines :) -Neil









https://uploads.tapatalk-cdn.com/2017...9edb1c1244.jpg