Anybody installed OEM backup parking sensors yet?

[kwbdc]

check out this thread. Might have what you need. http://www.audizine.com/forum/showth...013-B8-5/page5

[Peeet]

No I'm still trying to figure out where the can bus wires go exactly but no one got back to me yet

Canbus wire DIY -> http://www.audizine.com/forum/showth...1#post10918759

So for the red wire to the fuse box, where exactly does it go to the fuse panel? there's like 50 slots....

Power from PDC, goes to a fusebox, thats only has power when the ignition is on.
That is becauce of the state of your battery in your car.
Normally that is the black fusebox holder (red and brouwn fusebox has permanent 12 Volt).
Check it with a multimeter, of there is no 12 Volt with the ignition off, and there is 12 Volt with the ignition on

Peeet



PDC DIY -> http://www.audizine.com/forum/showth...1#post10917032

Complete PDC DIY in my retrofit topic on the Dutch Audi forum
All Elsawin instructions, Ekta partlist, drawings and more than 165 picutures off it -> http://www.audiforum.nl/forum/audifo...ml#post1668764