Originally Posted by awhk82 View Post
I have disabled the reverse light bulb error check with VAGCOM. Now running LED bulbs without any issue.
Here are the steps:
Module 46 Central Convenience > Security Access 16 > 16017
Adaption 10 > Channel 181 > Convert your decimal number to binary (for example my default number in decimal is 65535, converted to binary = 1111111111111111), then change bit 10 and 11 from 1 to 0 (my new binary value becomes 1111001111111111, which is 62463 in decimal) > Enter the new binary value > Test > Save
I have disabled the reverse light bulb error check with VAGCOM. Now running LED bulbs without any issue.
Here are the steps:
Module 46 Central Convenience > Security Access 16 > 16017
Adaption 10 > Channel 181 > Convert your decimal number to binary (for example my default number in decimal is 65535, converted to binary = 1111111111111111), then change bit 10 and 11 from 1 to 0 (my new binary value becomes 1111001111111111, which is 62463 in decimal) > Enter the new binary value > Test > Save
Open trunk lining to access rear lights
Just 2 clips holding it in place
Access to internals
Just one screw holding it in place; remove it
Unattach 2 wires to remove circuity board
Internal Board
Pull to remove old bulb, replace with new LED
Comparison with old bulb
New LED reverse light (sorry guys, I tinted my reverse and turn signal lamp area, else it could have been brighter)
Reply With Quote
Bookmarks