Couple quick questions about Pioneer install in B7 w/Connects2 adapters & what not

[8520]

What you should need is front speaker level hooked up and rear rca outputs, as well as the amp turn on connected.

So in this harness for example -

http://enfigcarstereo.com/shopsite_s...RA_70_1787.jpg

You hook up the white, white-black, grey and grey-black to their corresponding colors on the pioneer harness and the purple and green rcas to the rear rca outputs on the pioneer deck.

Make sense?

[Jer]

What you should need is front speaker level hooked up and rear rca outputs, as well as the amp turn on connected.

So in this harness for example -

http://enfigcarstereo.com/shopsite_s...RA_70_1787.jpg

You hook up the white, white-black, grey and grey-black to their corresponding colors on the pioneer harness and the purple and green rcas to the rear rca outputs on the pioneer deck.

Make sense?

Yeah, it makes sense and that's exactly what I did. Still no rear audio. I wonder if I'm plagued with the lack of rear RCA output voltage that some have claimed. I guess a line driver tends to solve the issue but there HAS to be another fix. This Pioneer is putting out WAY more than the 2 volts that the factory setup was sending to the rear amp. But the end result is properly wired and no rear audio. I found it interesting though that I could disconnect all speaker wires and the rears/sub worked fine. Doesn't make sense that with the deck feeding/amping the front speakers at about 20 watts RMS it would draw too much power to send a few volts to the RCAs.