noob question but would the b7 DTM rear fit on a b6?

[KOTO]

my guess is not cause of the tail light setup but maaybee? no?

[mattman]

It could fit....would need quite a bit of modification around the taillight area though....

[KOTO]

yeah i've been trying to visually compare photos. seems one would need to hack a bit of material from it to fit under the fatter/lower b6 lights. other than that it seems pretty straight foward.

anything else i'm missing?

[CyberPMG]

I'm gonna say "no" because of the tail lights. Also looks like a Euro bumper which means you would need new rebar and supports unless you already have an Ultrasport rear bumper.

[KOTO]

i dont know, other than the euro bumper and cutting the top part next to the lights i dont see any other problem.

the b7 and b6 trunks are the same size other than the lights on the b7 trunk right?

i'll look into more detail tonight. this is def on my to do list for the summer/fall.

[Lusticles]

are the trunks different

[KOTO]

ok so after much visual comparison i think that the b7's bottom end rear quarter panels are slightly horter than the b6's

soo i'm guessing that obviously the sides of the bumpers for the B7 are thicker hence the B6 bumpers are thinner

which would mean you would have to hack into the b6 rear quarter panels to get the whole thing to fit.

i may be wrong, i'l be able to measure it this weekend from a friends DTM but just from visuals looks like you would have to hack the rear quarter panel to get the bumper to fit and then the DTM bumper itself as well to get it to fit under the tail lights. not worth it for me :( another dream down the drain. UNLESS both rear quarters are the same then we might have something :D