I'm installing some LED all around and of course getting the bulb out message. But before I hack up my wiring to install load resistors I wanted to see if we can just disable the diagnostic check. I've searched but haven't found anything for Audi, but looks like its possible on Vdubs.

For the MKV:
Byte 18 Bit 0 Cold Diagnosis License Plate Lights active
Byte 18 Bit 1 Cold Diagnosis Brake Lights active
Byte 18 Bit 2 Cold Diagnosis Front Fog Lights active
Byte 18 Bit 3 Cold Diagnosis Rear Fog Lights active
Byte 18 Bit 4 Cold Diagnosis High Beam active
Byte 18 Bit 5 Cold Diagnosis Turn Signals active
Byte 18 Bit 6 Cold Diagnosis Back Light active
Byte 18 Bit 7 Cold Diagnosis Side Turn Signals active
Byte 19 Bit 0 Cold Diagnosis Low Beam active
Byte 19 Bit 1 Cold Diagnosis Front Parking Lights active
Byte 19 Bit 2 Cold Diagnosis Rear Parking Lights active
Byte 19 Bit 3 Diagnosis Rear Parking Lights active

I suspect we should have something similar. I really don't like the idea of hacking up the wiring of my DRL, city lights, license plate lights, etc. to add load resistors. Anyone got ideas?