Car wont start. Throwing Cam Sensor Code. Help Bros

[gullatec]

hey guys. So i noticed I was getting shitty gas mileage and next thing i know, CEL. woo. So I took it in to the boys at Induktion Motorsports and they VAG'd it, throwing a code (off the top of my head)

CAM POSITION SENSOR- READING TOO HIGH blah blah blah (i wish i would have kept the paper)

Needless to say, they cleared and off I drove. Two days later it was back, and the car wouldnt start. After about 10 minutes of trying, I popped the hood, saw nothing wrong, and it started back up. 24 hours, it took 3 key cranks to turn over. I am going to take it in tomorrow to induktion. Any suggestions or stories about this code? How screwed am i?

Also: I got an oil change 2 weeks ago, 5w-30 pennzoil platinum full synthetic, i dont know if that could be related. Thanks guys.

[Klum00]

where did you get the oil changed? check the dipstick to make sure you have some in there, but the viscosity seems ok...

[gullatec]

where did you get the oil changed? check the dipstick to make sure you have some in there, but the viscosity seems ok...

my buddy owns 2 jiffy lubes in the area and I saw them change it. It's dark and im drunk so im gonna check it in the morning. thanks for the advice aaron

[trueno429]

same problem happened to a passat 1.8t that came into the shop i used to work at during the summer..i changed the camshaft sensor and it solved the problem..its easy to change just pop off the timing belt cover theres 2 clipss

[Fit4aking]

Hey did you get to reset the light? Any other concerns since the sensor swap?

Thanks again!