im using ATPs log mani (side mount). im using a Tial 38mm WG. i thought i heard someone saying there was an issue with bolting the WG right up to the mani. instead to use an "elbow" of some sort to move the WG over a little...
is this so? am i just totally wrong? i only have one day to replace my Eliminator setup for a full on 50 trim setup..... therefore i have to have everything figured out as there is no time to deal with those happy little surprises that ALWAYS pop up when ever motors are built up
also, where should i route my dump tube? (we have a TIG welder but im not sure we'll have the time to run the dump back into the DP)
as always, thanks so much!!!!
Bookmarks