search of an FMIC with no modding.

**AsianA408** · 01-13-2009 07:25 PM

it just doesnt mutha Fin exist.

all of them toss the rebar, and or cut the shiet out of the bumper.
even if we have a rieger. kerscher, oem rs4 front.

true?

**jamestown478** · 01-13-2009 07:26 PM

that would look sick as hell to have a front mount mounted up flush to the edge of a bumper

**infinkc** · 01-13-2009 09:19 PM

better off running some smics cause if you don't cut anything the core will be super small.

**s vier** · 01-13-2009 09:41 PM

I think I might have a pic from mine.... (looking)

**Sleeeper X** · 01-14-2009 06:10 AM

Originally Posted by AsianA408

it just doesnt mutha Fin exist.

all of them toss the rebar, and or cut the shiet out of the bumper.
even if we have a rieger. kerscher, oem rs4 front.

true?

its called autospeed

**wdbdy2000s4** · 01-14-2009 06:18 AM

for 1800 bux i would rather buy a JHM front mount and an extra bumper to hack up. Then I would have enough left over to buy a euro rear bumper too.

**S4-Casa** · 01-14-2009 12:14 PM

The only really cutting is from the fog lights - and the rebar - KEEP the rebar its doable
just need a sawzaw or rotary cutter of some sort. Look at JHM's site for exact cuts.
Otherwise its a great investment for the power output.

**Jung** · 01-14-2009 03:35 PM

S Vier and I first used a sawzall on the bumper support, but it takes forever to cut. Angle Grinder is your best bet for cutting. you don't have to cut ANY of the bumper itself, just the supports. JHM makes it fit, so can you.

**Sleeeper X** · 01-15-2009 09:11 AM

Originally Posted by wdbdy2000s4

for 1800 bux i would rather buy a JHM front mount and an extra bumper to hack up. Then I would have enough left over to buy a euro rear bumper too.

its not a JHM fmic. Its an ebay FMIC with jhm piping.

**NYCVR6** · 01-15-2009 10:10 AM

Originally Posted by TommyGunn

its called autospeed

Autospeed you need to cut up the bumper support.

**slow ride** · 01-15-2009 06:18 PM

Just not enough room in the front of these cars. I did the ebay core with my own pipes that I made from 2" piping/elbows. I have the foglights and side grills installed on car and working just fine. I had to trim and modify the grills a lot, but ended up with a very stock looking ebay setup.